工程计算器
Voltage Coefficient (VCR) Error Calculator
如何读懂图表。 The top resistor changes value as the voltage across it rises, so the ratio at 20 kV is not the ratio you measured on the bench. The curve is that drift and dR/R is the error the calculator returns.
A thick film resistor is not the same value at 20 kV as on a bench meter. VCR is quoted in ppm per volt; this turns it into the resistance change and the divider error it causes.
输入
功能验证
- R1 change
- -
- Ratio at 0 V
- -
- Ratio at working V
- -
- 比率误差
- -
- Output at working V
- -
其计算公式
ΔR/R = VCR × V / 1,000,000. Divider ratio = (R1 + R2) / R2; recalculate it with the shifted R1 to get the error.
计算器不包含的内容
- TCR。 The resistor also drifts with temperature and the two effects add. A part with −1 ppm/V and 25 ppm/°C can drift more from a 40 °C rise than from full voltage.
- Non-linearity. VCR is not perfectly linear; the quoted figure is typical at rated voltage.
- Self-heating. Current through R1 raises its temperature, which shifts the value again.
选择零件
Where the ratio matters, specify VCR explicitly: the 平面厚膜范围 is quoted for precision divider use, tolerance from 0.2%. For matched pairs, send the ratio and the voltage.
请发送计算值和税率: 索取技术报价6小时内回复。