工程计算器
High Voltage Resistive Divider Calculator
How to read the diagram. Vin sits across the whole string, R1 on top and R2 to ground, and Vout is taken at the junction. Both resistors carry the same current, so the ratio R2 / (R1 + R2) alone sets Vout.
Enter the input voltage and the two resistor values. The calculator returns the output voltage, the division ratio and the current through the chain — the three numbers that decide whether a divider is practical before tolerance and voltage coefficient are considered.
输入
功能验证
- 输出电压
- -
- Division ratio
- -
- Chain current
- -
- Total dissipation
- -
- R1 / R2 voltage
- -
其计算公式
Vout = Vin × R2 / (R1 + R2). The current through the chain is Vin / (R1 + R2), and the total dissipation is Vin² / (R1 + R2). In a high voltage divider, R1 usually carries most of the voltage, so R1 is the resistor that sets the voltage rating of the chain, not R2.
What the calculator does not include
Three effects change the real output voltage and none of them appear above:
- Voltage coefficient. A thick film resistor changes value as the voltage across it rises. At 20 kV across R1, a VCR of −1 ppm/V shifts the resistance by 2%, and the ratio with it. Precision dividers are specified with VCR below 1 ppm/V for this reason.
- Tolerance and matching. A ±1% R1 and a ±1% R2 can move the ratio by up to about 2% in the worst case. A matched pair, or a ratio trimmed at the factory, is the usual fix.
- 正在加载。 The meter or ADC across R2 is in parallel with it. If the input impedance is not at least 100 times R2, the divider ratio changes.
Choosing the resistors
For a divider up to 35 kV, the planar thick film range covers 200 Ω to 1 TΩ with tolerance from 0.2%. Above that, or where the chain must dissipate watts, the power bar range goes to 150 kV. The resistor overview maps all three form factors.
Send the calculated values and the accuracy you need: request a technical quote6小时内回复。